Please Log in or Create an account to join the conversation. I am skeptical to doing the latter as spikes and kickback from solenoids hitting the 7i77. I either have to ring out the wiring to seperate and use two power supplies otherwise use existing 24vdc PS to power solenoid and valves and use it for field power for the 7i77. common +24vdc sitting on all the relays, then sending the 24VDC line out to drive the solenoids and valves and having common line going out to all the solenoid and valves. The issue is they are sending +24vdc on line say P3, then sending the single lines back to input and the opposite for the relays. There is an existing 24VDC power supply, but I think I will leave that to drive all the solenoids and valves and add a 24vdc power supply for field power for the 7i77. BIESSE ROVER 13SCNC ROUTERUSED BUT IN VERY GOOD CONDITIONTHIS IS THE COMPUTER CONTROLLED ROUTER YOU HAVE ALWAYS BEEN WANTINGUses Biesse Software and others. All low voltage is 24vdc for all solenoids and air valves. Biesse Rover 20 User Manual - Legacy Pdf Book Manual. ROVER Tooling System which is a software. This Biesse Rover 20 Is A Great CNC Machine, Very Well Taken Care Of And In. I have to check the relay boards but I think I can use them and have the 7i77 drive the relays. BIESSE cannot be considered responsible or liable for damage resulting from. Not so bad, no schematics so have to trace wiring to be sure.
0 Comments
Leave a Reply. |